Hi...
As for manufacturing / assembly of pipe in vehicle, there is need of bend location information along with bend location balloons in piping drawing ( at least start point and end point ).
So please can any one suggest how to create it with minimum effort. as like BOM Balloons. If any direct functionality available then it is well and good because its a compulsory need for every piping designer.
In above image shown bend table with its points e.g. P1, P2, P3 ...etc. ( which is created by repeat region). So in this drawing Balloons should be create automatic for points P1, P2, P3 ...
Thanks & Regards,
Prashant Pandarkar